Vaisala DRYCAP DMT340 SERIES Guia do Utilizador descarregar pdf (Página 46)

USER'S GUIDE____________________________________________________________________

46 __________________________________________________________________ M210704EN-E

CAUTION

In pressurized processes it is essential to tighten the supporting nuts and

screws very carefully to prevent loosening of the probe by the action of

pressure.

NOTE

When the DMT340 is installed in a process with a pressure differing

from the selected operating pressure at the time of ordering, please enter

the pressure value of the process into the transmitter memory, see

section Pressure Compensation Setting on page 101. Use the serial line

commands XPRES and PRES or the display/keypad. The pressure set

buttons on the mo

therboard inside the transmitter can also be used to set

pressure compensation.

Ball Valve Installation Kit for DMT348

The ball valve installation kit (Vaisala order code: BALLVALVE-1) is

preferred when connecting the probe to a pressurized process or pipeline.

Use the ball valve set or a 1/2" ball valve assembly with a ball hole of

ø14 mm or more. If you install the probe (ø12 mm) in a process pipe,

please note that the nominal size of the pipe must be at least 1 inch (2.54

cm). Use the manual press handle to press the probe into the pressurized

(< 10 bar) process or pipeline.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 168 169

Sem comentários

Vaisala DRYCAP DMT340 SERIES Guia do Utilizador Página 46