Vaisala BAROCAP PTB330 Guia do Utilizador descarregar pdf (Página 99)

Chapter 4 ________________________________________________________________ Operation

VAISALA_______________________________________________________________________ 97

When several barometers are connected to the same line, each

barometer must be entered an own address in the initial configuration,

and POLL mode must be used.

INTV

Use the INTV command to set the RUN mode output interval.

INTV [n xxx]

Sets the RUN mode output interval. The time interval is used only when

the RUN mode is active. For example, the output interval is set to 10

minutes.

>INTV 10 min

Output interval: 10 min

Setting RUN output interval to zero enables the fastest possible output

rate.

ADDR

Addresses are required only for POLL mode (see serial line command

SMODE on page 82). Use the ADDR command to input the RS-485

barometer address.

In RUN mode: outputting automatically, only the command S or

pressing the ESC key can be used to stop.

In POLL mode: measurements output only with command SEND

[addr]

where

n = 0...255

xxx = S, MIN or H

where

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 137 138

Sem comentários

Vaisala BAROCAP PTB330 Guia do Utilizador Página 99