
User's Guide ______________________________________________________________________
64 __________________________________________________________________ M210855EN-C
Relay Settings
Relay Outputs
0705-185
Figure 35 Relay Indicators on Display
Use the display/keypad to set the relay outputs.
1. Press any of the arrow buttons to open the MAIN MENU.
2. Select Interfaces and press the right arrow button to confirm your
selection.
3. Select Relay Outputs and press the right arrow button to confirm
your selection.
4. Select Relay 1/Relay 2 by pressing the right arrow button. Use the
up/down arrow buttons to select the quantity and press SELECT
to confirm your selection.
5. Select Quantity, press the CHANGE button. Select quantity by
using the up/down arrow buttons. Confirm your selection by
pressing the SELECT button.
6. Select Act. above/Act. below. Press the SET button. You may be
asked, whether you want to modify the value or remove the
setpoint. In this case, select MODIFY to adjust the value or
REMOVE to clear the setpoint. Adjust numeric values by pressing
the up/down/left/right arrow buttons. Confirm your selection by
pressing the OK key.
The number refers to Figure 35 on page 64:
1 = List enabled relays. Activation state is shown in black.
Disabled relays are not shown.
Comentários a estes Manuais