
User's Guide ______________________________________________________________________
70 ___________________________________________________________________M210630EN-B
0201-031
Figure 55 QMP213 with Installation Accessories
To install the unit, follow the procedure below:
1. Attach the unit through the holes in the upper end (number 1 in
Figure 55 on page 70) with the provided accessories (2) to the mast.
The cable inlets should face down.
2. Lead the mains power cable through the opening (4) and connect
the wires under the screws into the locations marked with L and N.
Tighten the inlet nut properly.
3. Connect the output power cable (3) to the power connector of
MAWS.
Solar/Mains Power Supply QMP201C
Solar/Mains Power Supply QMP201C is delivered with a connector
cable for MAWS. The unit is attached to the tripod's leg.
Comentários a estes Manuais