Vaisala WMS302 Guia do Utilizador descarregar pdf (Página 130)

User's Guide ______________________________________________________________________

128 __________________________________________________________________M210630EN-B

4. If the parameter is numeric, it is recommended that you also select

a measure unit for it. If the parameter is used as a station-specific

calculation parameter, you should provide it with a correct unit,

because otherwise the calculation configuration may not allow you

to use the parameter as input. If there is no suitable unit available,

select unspecified. This makes the parameter applicable for all use.

5. Enter a default value for the parameter.

The value of a static parameter, which can be a default value given in

MAWS Lizard, can be changed in the Station Settings window of

MAWS Terminal. The Static Parameters tab shows all parameters and

their values, also those that have been set directly with the MAWS

Terminal software, see Figure 115 on page 128. To change the value of

a static parameter, proceed as follows:

1. Start MAWS Terminal and select Station Settings from the Tools

menu.

2. In the Static Parameters tab of the Station Settings window,

double-click the corresponding Value cell. Enter the new

parameter value.

0405-052

Figure 115 MAWS Station Settings Window

3. Click Save to store the new parameter value to MAWS. You can

also change multiple values and save them all at once.

NOTE

All parameters are automatically created to the logger when the setup

is uploaded.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 261 262

Sem comentários

Vaisala WMS302 Guia do Utilizador Página 130