Vaisala WMS302 Guia do Utilizador descarregar pdf (Página 196)

User's Guide ______________________________________________________________________

194 __________________________________________________________________M210630EN-B

NOTE

You must load an appropriate setup to MAWS before you are able to

use the Sensor Calibration tab.

NOTE

The Sensor Calibration tab is not visible for setups made with

MAWS software versions prior to 3.06. With old setups, MAWS

common parameters frame only shows the calibration values for the

wind direction and solar radiation sensors. Other sensors need to be

calibrated through the terminal connection with the appropriate

calibration commands.

NOTE

When Value is expressed as N/A, it indicates that the calibration factor

has been altered but not saved, the sensor has not been measured or the

measurement channel of it has failed, or the sensor is disabled. Further

information about the possible reason can be obtained by comparing

the value in the Status column against the values listed in Table 16 on

page 132.

Table 28 Columns in the Sensor Calibration Tab

Column Description Input

Sensor The sensor name as

defined in the setup.

n/a

Channel The measurement channel

of the sensor.

n/a

ID The measurement identifier n/a

Status The sensor status n/a

Value The last measured sensor

reading shown in physical

units.

Overwrites the sensor reading

with the entered value, that is,

changes the offset of the

measurement.

Cal.Factor The measurement gain for

the sensors, except for the

radiation sensors (QMN10x

and QMS10x) the

sensitivity value.

Overwrites the old gain value

with the new one. For radiation

sensors (QMN10x and

QMS10x), changes the

sensitivity value.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 261 262

Comentários a estes Manuais

Sem comentários

Vaisala WMS302 Guia do Utilizador Página 196

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Vaisala WMS302