Vaisala HMP260 SERIES Manual de Serviço descarregar pdf (Página 109)

HMP260 SERIES

HMP260-U017en-1.5 Appendix 4: Digital current loop module

POLL mode

If a transmitter has been set to POLL mode, it will respond only to commands sent with

its address:

send 22

RH= 24.4 %RH T= 29.1 'C

Addresses from 1 to 99 can be used. According to the 20 mA current loop standard

current flows with no transmission on line. A maximum of 6 devices can be connected

on same single loop line, but the number can be raised to 9 by using dual loop wiring.

Current loop settings

HMP260 settings single pair dual pair

Full duplex/half duplex HDX FDX

Echo on/off OFF ON

Terminal settings

Line feed after carriage return yes no

HDX/FDX FDX FDX

When terminal is set to general <lf> (line feed) after <cr> (carriage return), the listings

will have two line feeds where also the HMP260 transmitters send line feed.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 117 118

Sem comentários

Vaisala HMP260 SERIES Manual de Serviço Página 109