Vaisala PTB220 Series Guia do Utilizador descarregar pdf (Página 51)

CHAPTER 6________________________________________________________________ OPERATING

VAISALA _________________________________________________________________________ 45

SEND Outputting a single message only

SEND <cr>

This command is used to output one message at a time in the STOP

and RUN modes.

Example:

>reset <cr>

PTB220 / 2.02

>send <cr>

1013.25 hPa

The user may also use his own previously specified one-message

command (see Chapter SCOM command on page 12).

V Verification message

V <cr>

The V command is used to output the verification message of the

barometer. The verification message outputs the nominal pressure

range of the barometer.

>v <cr>

VAISALA DIGITAL BAROMETER

PTB 220

500.00 to 1100.00 hPa

DNOS Self-diagnostics

DNOS <cr>

The DNOS command is used to perform a self-diagnostic routine in

the barometer. If no errors are found, the barometer outputs a PASS

message. In case of error, the barometer outputs an ERR message.

Example:

>dnos <cr>

PASS

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 112 113

Sem comentários

Vaisala PTB220 Series Guia do Utilizador Página 51