Vaisala HUMICAP HMP46 Guia do Utilizador descarregar pdf (Página 44)

HMI41 AND PROBES

Operating Manual M210316EN-A

10.2 Checking the settings

Turn the HMI41 on and enter the setup mode (see Chapter 8). Make sure that

the following settings are correct:

setting correct value

probe

AUT (all probes) or

1 (with HMP41/45) or

2 (with HMP46)

start (*)

baud

4.8

seri

E.7.1

calib

def (**)

(*) values 2, 3 and 4 are for calibration cables

(**) when the calib setting is entered, the value is always “no”; factory

settings for calibration correction data can be returned by selecting “def”

If the settings are not correct, change them: in the setup mode, select the

setting with ENTER, change it with buttons ▲ or ▼ and acknowledge with

ENTER. If the error message still appears, write it down and contact Vaisala

or a Vaisala representative for further instructions.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 71 72

Sem comentários

Vaisala HUMICAP HMP46 Guia do Utilizador Página 44