Chapter 4 ________________________________________________________________ Operation
VAISALA ______________________________________________________________________ 107
Using Serial Line
?
Use the serial line command ? to check the current transmitter
configuration. Command ?? is similar but can also be used if the
transmitter is in POLL mode.
Example:
>?
PTU300 / 3.01
Serial number : A2150004
Batch number : A1450004
Adjust. date : 2006-01-22
Adjust. info : (not set)
Date : 2006-02-27
Time : 14:00:57
Serial mode : RUN
Baud P D S : 4800 E 7 1
Output interval: 150 s
Address : 0
Echo : OFF
Pressure : 1013.25 hPa
Filter : ON
Ch1 output : 4...20mA
Ch2 output : 4...20mA
Ch1 P low : 500.00 hPa
Ch1 P high : 1100.00 hPa
Ch2 T low : -40.00 'C
Ch2 T high : 60.00 'C
Module 1 : RELAY-1
Module 2 : BARO-1
>
HELP
Use the command HELP to list the commands.
Example:
>help
? ACAL ADDR AERR ALSEL
ASCL ASEL CDATE CLOSE CODE
CRH CT CTA CTEXT DATE
DELETE DIR DSEL DSEND ECHO
ERRS FCRH FDATE FILT FORM
FST FTIME HELP INTV ITEST
MODS NET OPEN PLAY PRES
R RESET SEND SERI SMODE
TEST TIME UNDELETE UNIT VERS
WLAN XPRES
>
Comentários a estes Manuais