Vaisala HUMICAP DMT132 Guia do Utilizador descarregar pdf (Página 50)

USER'S GUIDE____________________________________________________________________

48 __________________________________________________________________ M211289EN-A

Restore Factory Settings

Use the FRESTORE command to restore the factory settings to the

transmitter. All user settings will be lost, and the transmitter will return to

the factory calibrated state (user adjustment is cleared).

FRESTORE<cr>

Example:

>frestore

Restoring factory defaults...done

Saving settings...done

CAUTION

If you have changed the HUMICAP® sensor yourself, be aware that the

FRESTORE command clears all of the user adjustment parameters,

including the capacitance offset and gain that are set by the

CRH

command.

If you want to avoid having to perform the capacitance adjustment

procedure again, record the adjustment parameters shown by the

command before performing the

FRESTORE command. You can

afterwards restore the adjustment parameters using the

LI command.

See page 46.

NOTE

If the HUMICAP® sensor has been changed at a Vaisala Service Center

the factory calibration has been updated to match the new sensor, and it

will not be affected by the

FRESTORE command.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 73 74

Sem comentários

Vaisala HUMICAP DMT132 Guia do Utilizador Página 50