Vaisala HMT120 Manual do Utilizador descarregar pdf (Página 46)

User's Guide _______________________________________________________________________

44 ___________________________________________________________________ M211244EN-B

Restore Saved Settings

Use the RESTORE command to restore saved settings from transmitter

FLASH memory to RAM. All unsaved changes will be lost.

RESTORE<cr>

Example:

>restore

Restoring default settings...done

Reset Transmitter

Use the RESET command to reset the transmitter. Upon reset or power-

up, the transmitter enters the serial mode that has been set with the

SMODE command.

After reset the configuration is loaded from FLASH memory. That

configuration can be altered with SAVE-command.

RESET<cr>

Example (transmitter set to serial mode STOP, will output transmitter

software version at reset):

>reset

HMT120 / 0.1.0.001

Type "help" for command list

Restore Factory Settings

Use the FRESTORE command to restore the factory settings to the

transmitter. All user settings, including the user-performed calibration

corrections, will be lost. The transmitter will revert back to the factory

calibrated settings. Note that this only returns the factory settings of the

transmitter and not of the interchangeable probe (see section Restore

Probe RH Factory Calibration on page 34 and section Restore Probe T

Factory Calibration on page 35).

FRESTORE<cr>

Example:

>frestore

Restoring factory defaults...done

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 86 87

Sem comentários

Vaisala HMT120 Manual do Utilizador Página 46