Vaisala PTB210 SERIES Manual de Instruções descarregar pdf (Página 112)

BGC-FTIR Sensors | PTB 210 27

Operating Commands

To output one single pressure reading with two decimals (as used in the

programming of the weather station) use the command:

.P<cr>

For continous output of the pressure readings use the command:

.BP<cr>

The output depends on the measurement rate and the averaging setting (see

this section on page 26). Output is stopped by pressing the enter-key (<cr>).

To select a pressure unit use the command:

.UNIT.x<cr>

x unit x Unit

0 hPa (default) 6 kPa

1 mbar 7 Pa

2 inHg 8 mmH

3 psia 9 inH

4 torr 10 bar

5 mmHg

For output with the unit use the command:

.FORM.1<cr>

For output without the unit use the command:

.FORM.0<cr>

NOTE: Make sure to reset the barometer with the command .RESET<cr>

to activate the new settings. The settings can be checked with the

command ?<cr>.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 136 137

Sem comentários

Vaisala PTB210 SERIES Manual de Instruções Página 112