Vaisala HMT360Series Guia do Utilizador descarregar pdf (Página 57)

Chapter 4 ________________________________________________________________ Operation

VAISALA_______________________________________________________________________ 55

SEND Outputting Measurement Values

Syntax: SEND<cr>

This command outputs the measured values in one point.

R Activating Continuous Output

Syntax: R<cr>

With the command R the transmitter outputs measured values

continuously.

S Stopping Continuous Output

Syntax: S<cr>

The continuous outputting is stopped with the command S. If outputting is

active, this command is not echoed.

INTV Setting Output Interval

Syntax: INTV [n xxx]<cr>

Sets the output interval when the transmitter outputs measurement

readings. The time interval is used when the continuous output is active.

Example, the output interval is set to 10 minutes:

>intv 10 min

Output interval: 10 MIN

where

n = 1 ... 255

xxx = S, MIN or H

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 96 97

Sem comentários

Vaisala HMT360Series Guia do Utilizador Página 57