Vaisala WAT12 Guia do Utilizador descarregar pdf (Página 13)

Chapter 3 __________________________________________________ Installation

VAISALA__________________________________________________________11

Always mount the WAA151 Anemometer to the southern

end of the cross arm.

1. It is recommended that you remove the cup assembly

to ease installation.

2. Fit the 6-pin cable plug through the mounting flange at

the end of the cross arm, then connect it to the sensor.

See Figure 4 below.

3. The sensor fits to the cross arm in one position only.

Face the product label south and mount the sensor to

the flange by twisting. Note that the plastic washers (1)

should be inserted between the flange and the sensor.

See Figure 4 below.

4. Finally, tighten the screws (2) with an Allen key (3).

See Figure 4 below.

5. Mount the cup assembly and tighten its fixing screw.

0204-042

Figure 4 Mounting of Wind Sensor

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sem comentários

Vaisala WAT12 Guia do Utilizador Página 13