Vaisala MW15 Manual do Utilizador descarregar pdf (Página 14)

USER'S GUIDE____________________________________________________________________

14 __________________________________________________________________ M211034EN-A

Checking PC Line Baud Rate

You can check the MW11/12/15 PC line connection and baud rate by

following the steps below:

1. When the MW sounding system is in the SOND menu, press the

CMD/CMND key.

2. Select SYSGEN from the menu that opens. The system loads and

the display shows the message "MW11/MW12/MW15 SYSGEN".

3. Select GO ON. The display shows the message "Select SYSPAR

Group to Edit".

4. Select CONFIG. The display shows the message "Configuration

data".

5. Select LINES.

6. Press the DOWN key until the display shows the message "Line

Description: PC HCopy".

7. Press SELECT. The display display shows the message "Line

status: On".

8. Press SELECT. The display shows the message "Connect PC to:

P1".

9. Press SELECT. The display shows the message "Line speed (bps)

9600".

10. Press EXIT until the message "Accept changes (temporary

storage)?" appears.

11. Select NO. The display now goes back to SOND menu.

If the serial line in step 8 above is not P1/S1, use the serial line displayed

for the PC cable connection.

If the baud rate in step 9 above is not 9600, use the baud rate displayed

for the PC connection.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Sem comentários

Vaisala MW15 Manual do Utilizador Página 14